How to Replace Blower Motor Resistor 98-04 Dodge Intrepid
Difficulty: Beginner · About 25 min · Dodge Intrepid
Replace the HVAC blower motor resistor on a 1998–2004 Dodge Intrepid through the passenger-side duct access panel.
Tools you will need
- Flat blade screwdriver
- 8 mm socket and ratchet
- Needle-nose pliers
Parts and supplies
- Blower motor resistor
Steps
Open the duct access
Switch off the ignition and locate the passenger-side duct panel. Release its retaining clip and move the panel aside to expose the resistor and fan wiring.
Disconnect and remove the resistor
Unplug the resistor harness and separate the fan lead by releasing its lock. Remove the retaining bolts and withdraw the resistor from the HVAC housing.
Install the replacement
Orient the replacement with its retaining feature facing the passenger compartment and seat it fully. Start the bolts by hand, secure them evenly, then reconnect the fan lead and resistor harness.
Reinstall the panel and test
Return the duct panel to its original position and engage its clip. Run the blower through its speeds and check for proper operation; inspect the connector if a speed remains inoperative.
Check your vehicle’s repair manual for exact specifications and fit.