How to Check Engine Fluids 14-19 Toyota Tundra

Difficulty: Beginner · About 20 min · Toyota Tundra

Check key fluid levels on a 2014–2019 Toyota Tundra, including brake fluid, coolant, engine oil, power steering fluid, and windshield washer fluid.

Steps

1. Inspect brake fluid

   Look at the reservoir level and verify it falls between the minimum and maximum marks. Fluid should be clear to light yellow; a dark or cloudy appearance calls for diagnosis and service before simply topping it off.

2. Check coolant safely

   Let the engine cool fully before inspecting the coolant reservoir or radiator. Compare the reservoir level with its marks, and never remove a radiator cap while the system is hot or pressurized.

3. Read the engine oil level

   After allowing oil to drain back into the pan, remove the dipstick and wipe it clean. Reinsert it completely, pull it out again, and add the recommended oil gradually if the reading is low.

4. Inspect power steering fluid

   Check the fluid level at the reservoir using the vehicle's indicated marks. Burnt-smelling or dirty fluid should be investigated and serviced with the specified fluid rather than ignored.

5. Top up washer fluid

   Remove the washer reservoir cap and confirm fluid is above its minimum mark. Add suitable windshield washer fluid as needed, then reinstall the cap securely.

Check your vehicle’s repair manual for exact specifications and fit.