How to Replace Blower Motor 96-04 Nissan Pathfinder
Difficulty: Beginner · About 60 min · Nissan Pathfinder
Replace the passenger-side blower motor in a 1996–2004 Nissan Pathfinder by removing the lower trim panel, exchanging the motor, and checking fan operation at each speed.
Tools you will need
- Socket Extensions
- 8mm Socket
- 10mm Socket
- Ratchet
- Swivel
- Trim Tool Set
Parts and supplies
- Blower motor
Steps
- Remove the lower trim panels
Use a trim tool to release the door-frame foot panel. Remove the 10 mm fastener and hand nut securing the corner trim, then ease that panel away from its retaining clip.
- Disconnect and remove the blower motor
Unplug the motor connector and detach its air duct. Remove the motor's mounting bolts and lower the assembly out of the heater housing without pulling on the wiring.
- Install the replacement motor
Position the new motor in the housing and secure it with its mounting bolts. Reattach the duct and electrical connector, making sure the connector locks and the duct is fully seated.
- Reinstall trim and verify operation
Engage the corner panel's locating clip, reinstall its fastener and hand nut, then press the foot trim back into place. Turn the ignition on and test the blower through its available speeds.
Check your vehicle’s repair manual for exact specifications and fit.