How to Replace Window Regulator 01-07 Ford Escape

Difficulty: Intermediate · About 70 min · Ford Escape

Replace the front power window regulator on a 2001–2007 Ford Escape, supporting the glass before removing the regulator assembly.

Steps

1. Remove the door panel and water shield

   Remove the handle and pull trim screws, then release the panel clips and lift it away. Unplug the switch wiring and carefully peel back the water shield to expose the regulator.

2. Support the window and remove the regulator

   Loosen the glass fasteners, raise the glass by hand, and secure it with tape to the door frame. Unplug the motor, remove the regulator and motor fasteners, release the harness clip, and guide the assembly out through the door.

3. Install the replacement regulator

   Feed the new assembly through the access opening and secure its rails and motor. Reconnect the motor lead, lower the glass into its front and rear tracks, attach it to the regulator, and tighten the glass fasteners to specification.

4. Test and reinstall the door panel

   Reconnect the switch temporarily and test the window through its range, checking for smooth movement. Restore the water shield, reconnect the panel harness, and reinstall the panel, screws, handle bezel, and trim.

Check your vehicle’s repair manual for exact specifications and fit.