How to Replace Washer Fluid Pump 02-06 Nissan Altima
Difficulty: Beginner · About 90 min · Nissan Altima
Replace the washer-fluid pump on a 2002–2006 Nissan Altima by loosening the bumper cover for access. Catch spilled fluid, seat the pump in its grommet, and test for leaks and proper washer spray before finishing.
Tools you will need
- Floor jack
- Jack stands
- Trim tool set
- 10mm socket
- Ratchet
- Drain pan
Parts and supplies
- Windshield washer pump
- Washer fluid
Steps
Release the bumper cover
Remove the upper clips, wheel-well fasteners, and lower splash-shield screws. Pull the cover forward carefully; have a helper support it so wiring and tabs are not strained.
Remove the failed pump
Lower the reservoir neck if needed, unplug the pump, and place a pan underneath. Ease the pump from its grommet, let fluid drain, then disconnect the hose.
Fit the replacement pump
Connect the hose and electrical plug, then press the pump fully into the reservoir grommet. Refit the filler neck and add suitable washer fluid.
Refit the bumper and test
Align the bumper at the headlamp and side clips, then reinstall its wheel-well, lower, and upper fasteners. Test the washers and inspect the pump seal and hose for leaks.
Check your vehicle’s repair manual for exact specifications and fit.