How to Replace Front Brakes 02-07 Jeep Liberty
Difficulty: Intermediate · About 100 min · Jeep Liberty
Replace front pads and rotors on a 2002–2007 Jeep Liberty. Support the caliper during removal, use specified torque for the exact configuration, and restore firm pedal feel before driving.
Tools you will need
- Floor jack
- Jack stands
- 19mm wrench
- 12mm wrench
- 21mm wrench
- Large C-clamp
- Wire brush
- Torque wrench
Parts and supplies
- Front brake pads
- Front brake rotors
Steps
Secure the vehicle
Loosen wheel nuts on the ground, raise the front at approved points, and place jack stands securely. Remove the wheel and inspect pad and rotor wear.
Remove the caliper and rotor
Ease the piston back enough to clear the rotor, support the caliper so its hose is not strained, then remove the pads, bracket, and rotor.
Prepare and install replacement parts
Clean the rotor and brush corrosion from pad contact points. Lubricate only specified contact areas, install the new rotor and pads, then torque fasteners to vehicle specification.
Refit the wheel and test
Tighten wheel nuts in a star pattern to specification, lower the vehicle, and pump the pedal until firm. Check for leaks or warnings and test at low speed before normal use.
Check your vehicle’s repair manual for exact specifications and fit.