How to Replace Drivers Side CV Axle 08-13 Nissan Rogue

Difficulty: Advanced · About 120 min · Nissan Rogue

Replace the driver-side CV axle on a 2008–13 Nissan Rogue, disconnecting the ball joint and ABS wiring carefully and checking the transmission seal afterward.

Steps

1. Remove wheel and axle hardware

   Loosen the lug nuts and axle nut while the vehicle is on the ground. Straighten and remove the cotter pin, take off its retainer, then raise and support the vehicle and remove the wheel.

2. Free the axle from the hub

   Loosen the axle nut and tap the axle end carefully until it releases from the hub splines. Remove the nut and set it aside for replacement if required.

3. Separate the ball joint

   Remove the wheel-well shield clips and disconnect the ABS sensor connector. Remove the control-arm pinch fastener, then use an appropriate separator to release the ball joint from the knuckle.

4. Remove the old axle

   Move the knuckle outward and slide the axle from the hub. Place a drain pan below the transmission and pry the inner joint free, taking care not to nick the axle seal.

5. Install the replacement axle

   Inspect the transmission seal for damage. Align the inner splines and push the axle into the transmission until its retaining clip seats, then guide the outer end through the hub.

6. Reconnect the ball joint and sensor

   Seat the ball joint stud in the knuckle and reinstall the pinch bolt and nut. Reconnect the ABS sensor plug and reinstall the wheel-well shield and clips.

7. Install axle nut and wheel

   Install the axle nut and a new cotter pin and retainer as applicable. Refit the wheel, lower the vehicle, and torque the axle and lug hardware to the vehicle's specifications.

8. Check fluid and test drive

   Check transmission fluid level using the manufacturer's procedure and inspect the axle seal for leaks. Test gently, checking for vibration, clicking, or ABS warning lights.

Check your vehicle’s repair manual for exact specifications and fit.