How to Replace Washer Level Sensor 97-01 Toyota Camry
Difficulty: Intermediate · About 90 min · Toyota Camry
Replace the washer-fluid level sensor on a 1997–2001 Toyota Camry by removing the bumper cover and draining the reservoir. Seat the sensor seal correctly, reconnect the pump and sensor, and verify the warning clears.
Tools you will need
- Floor jack
- Jack stands
- 10mm socket
- Phillips head screwdriver
- Flat blade screwdriver
- Drain pan
Parts and supplies
- Washer-fluid level sensor
- Washer fluid
Steps
Remove and support the bumper cover
Remove the upper fasteners, raise and support the car safely, then remove lower and wheel-well fasteners. Release the bumper retainers and pull the cover away without straining nearby wiring.
Drain the reservoir and remove the sensor
Place a pan beneath the reservoir, disconnect the hose and pump wiring, and let the fluid drain. Release the pump and sensor from their seals, then unplug the level sensor.
Install the sensor and reconnect lines
Press the replacement sensor into its seal with its locating tab oriented correctly. Reconnect its plug, seat the pump, reconnect its hose and wiring, and secure the wheel liner.
Refit the bumper and refill
Align the bumper with its retainers and reinstall upper, lower, and wheel-well fasteners. Lower the car, refill the reservoir, and verify washer operation and the level warning.
Check your vehicle’s repair manual for exact specifications and fit.