How to Replace Sway Bar Link 03-07 Honda Accord

Difficulty: Intermediate · About 45 min · Honda Accord

Replace a front stabilizer link on a 2003–2007 Honda Accord after lifting and supporting the front end securely.

Steps

1. Lift and remove the wheel

   Loosen the lug nuts slightly while the tire is on the ground, chock the rear wheels, raise the front, and support it on jack stands at approved points. Remove the wheel to reach the link.

2. Remove the worn link

   Remove the nuts at the stabilizer bar and lower control arm. If a stud spins, hold it with locking pliers on its damaged end without gripping the boot; then remove the link from the vehicle.

3. Fit the replacement link

   Place the new link in the original orientation and start both supplied nuts by hand. Hold the studs as needed and tighten to the vehicle specification, checking that the boots remain seated and untwisted.

4. Reinstall the wheel and inspect

   Refit the wheel and start each nut by hand. Lower the vehicle and tighten the lug nuts in a crossing pattern to the vehicle specification, then check for contact or noise on a careful road test.

Check your vehicle’s repair manual for exact specifications and fit.