How to Replace Sway Bar Link 00-07 Volvo V70
Difficulty: Intermediate · About 40 min · Volvo V70
Replace a worn front sway bar link on a Volvo V70, routing it clear of the ABS lead and tightening both ends securely.
Tools you will need
- Floor Jack
- Jack Stands
- 19mm Socket
- 18mm Wrench
- 15mm Wrench
- Torque Wrench
Parts and supplies
- Front sway bar link
Steps
Raise the vehicle and remove the wheel
Loosen the lug nuts before lifting, then support the vehicle securely and remove the wheel to access the sway bar link.
Remove the old link
Counterhold the link stud as needed while removing its upper and lower nuts. Note how the link passes the ABS wiring, then remove it from the suspension.
Install the replacement link
Route the new link along the same path without trapping the ABS lead. Start both nuts by hand, counterhold the studs, then tighten to the vehicle specification.
Reinstall the wheel
Mount the wheel and hand-start its fasteners. Lower the vehicle enough to load the tire, torque the fasteners to specification in a star pattern, then lower fully.
Check your vehicle’s repair manual for exact specifications and fit.