How to Replace Interior Front Door Handle 01-06 Chrysler Sebring
Difficulty: Beginner · About 25 min · Chrysler Sebring
Replace the interior front door handle on a 2001–2006 Chrysler Sebring by removing the trim panel, transferring the lock switch, and reconnecting the latch rod.
Tools you will need
- Flat Blade Screwdriver
- T20 Driver
- Phillips Head Screwdriver
Parts and supplies
- Interior front door handle
Steps
Remove the panel fasteners
Switch off the ignition. Pry up the plastic covers behind the latch and pull handle, remove the Phillips screws beneath them, then remove the remaining panel-edge screws. Keep the screws grouped by location for reassembly.
Release the door panel
Carefully pry the mirror-corner trim and work around the panel edges with a trim-safe tool. Lift the panel enough to release the lock rod and disconnect its wiring harness, then set the panel on a protected surface.
Transfer the switch to the replacement handle
Remove the two T20 fasteners securing the handle assembly and release the switch clips. Fit the switch into the replacement handle and reinstall the fasteners, confirming the switch is fully seated.
Reinstall and test the door panel
Reconnect the wiring harness and clip the lock rod back into the handle. Align the door panel and press its clips into place, reinstall the Phillips screws and trim covers, then test the handle and lock before closing the door.
Check your vehicle’s repair manual for exact specifications and fit.