How to Replace Tail Light 93-99 Volkswagen Jetta

Difficulty: Intermediate · About 35 min · Volkswagen Jetta

Replace the tail light assembly on a 1993-1999 Volkswagen Jetta.

Steps

1. Remove the tail light assembly

   Open the trunk, pry out the four push clips with a flat blade screwdriver and peel back the trunk liner, unclip the bracket holding the bulbs and unplug them, remove the three 8mm nuts holding the assembly from inside the trunk, then pull the license plate off, remove the four screws holding the vanity panel behind it, unbolt the four nuts securing the tail lights to that panel, and pull the whole assembly out.

2. Install the new tail lights

   Bolt the new tail lights to the vanity panel with the 8mm socket, bolt the assembly back onto the car, plug the bulbs and wiring harness bracket back in, tighten all six nuts holding the tail lights to the trunk, refit the license plate, then clip the trunk liner back into place and close the trunk.

Check your vehicle’s repair manual for exact specifications and fit.