How to Replace Windshield Washer Reservoir 07-11 Toyota Camry
Difficulty: Intermediate · About 70 min · Toyota Camry
Replace a Toyota Camry windshield washer reservoir by loosening the bumper cover, transferring the pump and sensor, and checking for leaks.
Tools you will need
- 10mm Socket
- Phillips Head Screwdriver
- Trim Tool Set
- Drain Pan
Parts and supplies
- Washer fluid reservoir
- Washer fluid pump seal, if damaged
Steps
Loosen the front bumper cover
Mark the bumper position with tape, then remove the splash shield, wheel-liner, and bumper fasteners. Release the cover from its brackets without pulling on attached wiring.
Drain and remove the reservoir
Place a drain pan under the washer pump and unplug the pump and level sensor. Remove the bottle fasteners, free the sensor seal, and lower the reservoir out.
Install the reservoir and pump
Seat the sensor seal in the replacement bottle and install the level sensor. Fit the reservoir, reconnect the pump and hose, and secure all mounting fasteners.
Refit the bumper and test
Align the bumper with the marks, reconnect any harnesses, and reinstall its retainers and splash shields. Fill with washer fluid and test the spray and level warning.
Check your vehicle’s repair manual for exact specifications and fit.