How to replace Rear Sway Bar Links 03-08 Honda Pilot
Difficulty: Intermediate · About 90 min · Honda Pilot
Replace a rear stabilizer link on a 2003–2008 Honda Pilot, holding the link stud against rotation while removing its nuts and checking the assembly after the wheel is reinstalled.
Tools you will need
- 5mm Hex Wrench
- 14mm Wrench
- Socket Extensions
- Torque Wrench
- 14mm Socket
- Rust Penetrant
- Jack Stands
- 19mm Socket
- Ratchet
- Floor Jack
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear stabilizer bar link
Steps
- Raise the Pilot and remove the wheel
Loosen the wheel nuts before lifting the vehicle. Support the rear securely on jack stands, remove the wheel, and turn it as needed to make the stabilizer link fasteners accessible.
- Remove the old link
Hold the link stud with a 14 mm wrench while loosening its nut with a 5 mm hex tool. Repeat at the opposite end, then pull the link free from the stabilizer bar and suspension arm.
- Install the replacement link
Place the replacement link in the original orientation and start both nuts by hand. Hold each stud against turning as you tighten the nuts to the vehicle's specification.
- Refit the wheel and inspect the repair
Reinstall the wheel and hand-start its nuts. Lower the vehicle and tighten the lugs in a star pattern to the vehicle specification, then check that the link boots and fasteners are seated securely.
Check your vehicle’s repair manual for exact specifications and fit.