How to Replace Power Steering Pump 01-05 Honda Civic
Difficulty: Intermediate · About 75 min · Honda Civic
Replace the power steering pump on a 2001–2005 Honda Civic, keep fluid contained, inspect the hoses, and refill and check the system after belt adjustment.
Tools you will need
- 12mm Socket
- Socket Extensions
- Flat Blade Screwdriver
- Pry Bar
- 19mm Socket
- Drain Pan
- 10mm Socket
- Ratchet
- Cloth Rags
- Needle nose pliers
- 12mm Wrench
Parts and supplies
- Power steering pump
- Power steering fluid
Steps
Release pump belt tension
Place a drain pan beneath the pump area. Loosen the reservoir and pump mount fasteners, release the belt tension, and slip the belt off the pump pulley.
Remove pulley and disconnect lines
Hold the pulley securely while removing its retaining nut, then lift the pulley off. Disconnect the pressure line and hose, allowing fluid to drain into the pan.
Remove the old pump
Remove the pump mounting fasteners and separate the pump from its bracket. Inspect the connected hoses and fittings for cracks, leaks, or damaged sealing surfaces.
Prepare and connect the replacement pump
Clean the reservoir and transfer any reusable fittings as required. Remove shipping plugs, attach the pressure line and return hose, and tighten the connections to the vehicle's specification.
Install the pulley and pump
Fit the pulley in the correct orientation and secure its nut. Position the pump in its mount, start its fasteners, route the belt correctly, and adjust belt tension to specification.
Refill and check the system
Secure the reservoir and fill it with the specified fluid. Start the engine and turn the steering slowly from side to side without holding at full lock; check the level, belt, and connections for leaks.
Check your vehicle’s repair manual for exact specifications and fit.