How to Replace Broken Exterior Door Handle 07-10 Hyundai Elantra
Difficulty: Beginner · About 20 min · Hyundai Elantra
Replace a broken exterior door handle on a 2007–2010 Hyundai Elantra through the door-edge access opening, retaining the inner nut and checking the handle's latch engagement.
Tools you will need
- Socket Extensions
- Locking Pliers
- 8mm Socket
- Telescope magnet
- Ratchet
- Pocket Screwdriver
Parts and supplies
- Exterior door handle
Steps
Open the access point
Open the door and remove the rubber access-hole cover from the door edge. Use an 8 mm socket to loosen the handle fastener through the opening, taking care to retain the nut on the inner side so it does not drop into the door.
Remove the damaged handle
Release the handle retainer if needed, then slide the broken handle out of its front and rear mounts. Retrieve any loose fastener or clip before installing the replacement.
Fit and secure the replacement
Insert both ends of the new handle into their door openings and slide it forward until it engages the internal pull bar. Reinstall the retainer and tighten the 8 mm fastener while holding the inner nut steady.
Test the latch before closing
Reinstall the rubber access cover and operate the handle several times with the door open. Confirm the latch releases and returns correctly, then close the door gently and verify it opens normally from both inside and outside.
Check your vehicle’s repair manual for exact specifications and fit.