How to Replace Window Regulator 98-02 Honda Accord

Difficulty: Intermediate · About 60 min · Honda Accord

Replace a Honda Accord window regulator with the glass secured in place, then verify smooth movement before reinstalling the moisture barrier.

Steps

1. Remove the door panel

   Remove the handle and pull covers and screws, disconnect the window switch and latch rod, then release the panel clips. Unplug the courtesy light and peel back the water shield.

2. Secure the glass and remove the regulator

   Support the glass while freeing it from the regulator track, then raise and tape it securely. Remove the regulator bolts and motor lead, then withdraw the assembly.

3. Install the replacement regulator

   Guide the new regulator into the door and start its fasteners. Reconnect the motor, lower the glass onto the track, and tighten its retainers evenly.

4. Test and restore the door

   Operate the window through its travel and listen for binding. Refit the water shield, courtesy light, pull bracket, latch rod, wiring, and door panel.

Check your vehicle’s repair manual for exact specifications and fit.