How to Replace Heater Blower Motor 98-04 Dodge Intrepid
Difficulty: Beginner · About 30 min · Dodge Intrepid
Replace the heater blower motor on a 1998–2004 Dodge Intrepid by lowering the passenger-side air duct, transferring the cover and wiring, and testing the fan.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Socket Driver
- 8mm Socket
- Ratchet
Parts and supplies
- Heater blower motor
Steps
Move the air duct for access
Switch off the ignition and work from the passenger footwell. Release the push clips securing the duct in front of the blower motor and move the duct aside without bending or cracking it.
Disconnect and remove the blower motor
Unplug the motor connector, then remove the 8 mm fasteners holding the blower motor and its cover. Lower the motor from the HVAC housing and keep its wiring clear of the fan wheel.
Install the replacement motor
Position the new motor in the housing and secure it with the 8 mm fasteners. Route the wiring lead through the plastic cover, install the cover, and reconnect the electrical plug until it locks.
Restore the duct and test the fan
Reinstall the duct push clips, seating each clip body before pressing its center pin. Turn on the ignition and test the blower at each speed, checking for rubbing, vibration, or loose wiring before reinstalling any remaining trim.
Check your vehicle’s repair manual for exact specifications and fit.