How to Replace Rear Shocks 09-14 Ford F-150
Difficulty: Intermediate · About 60 min · Ford F-150
Replace the rear shock absorbers on a 2009–2014 Ford F-150 in pairs, supporting the truck securely and tightening the upper and lower mounts to specification.
Tools you will need
- Floor jack and jack stands
- 15mm socket
- 18mm wrench
- Breaker bar
- Torque wrench
Parts and supplies
- Rear shock absorbers, pair
Steps
Loosen the upper shock mount
Park on level ground and loosen the upper shock fastener while the truck is supported safely. Do not remove the fastener until the vehicle is properly supported.
Raise and support the truck
Raise the rear and support the frame with appropriately rated jack stands. Remove the wheel if needed for access and support the axle as required by the service procedure.
Remove the old shock
Remove the lower shock fastener and then the upper fastener. Withdraw the shock and repeat on the opposite side if replacing both.
Prepare and install the replacement
Cycle each new shock by hand as directed by its manufacturer. Position it between the mounts, install the lower and upper fasteners, and tighten them to the vehicle's specification.
Lower and recheck
Lower the vehicle safely and confirm both shock mounts are secure. Inspect for correct clearance and take a cautious test drive, listening for unusual noise.
Check your vehicle’s repair manual for exact specifications and fit.