How to Replace Ignition Coil 01-07 Ford Taurus

Difficulty: Beginner · About 25 min · Ford Taurus

Replace the ignition coil on a 2001–2007 Ford Taurus and reconnect the six plug wires in their original positions.

Steps

1. Label and unplug the ignition wires

   With the engine off and cool, mark each of the six plug wires by coil position before removing them. Release the electrical connector lock and unplug the coil harness without pulling on its wires.

2. Remove the old coil pack

   Remove the three small mounting bolts and lift the coil pack out. Inspect the plug wire boots and connector for oil, corrosion, or damage before fitting the replacement.

3. Install the replacement coil

   Position the new coil in the same orientation, start the mounting bolts by hand, and tighten them securely without overtightening the housing. Reconnect the electrical plug until its latch engages.

4. Reconnect the plug wires and test

   Attach each wire to its original marked tower and push until its boot is fully seated. Start the engine and check for smooth running; if it misfires, switch off and recheck wire placement and connector engagement.

Check your vehicle’s repair manual for exact specifications and fit.