How to Replace Driver Seat Switch 07-16 Ford Escape
Difficulty: Beginner · About 20 min · Ford Escape
Replace the driver seat switch on a 2007–2016 Ford Escape by removing the seat-side trim, disconnecting the switch, and reinstalling the adjustment handle.
Tools you will need
- T20 Torx driver
- Pick tool
Parts and supplies
- Driver seat switch
Steps
- Remove seat-side trim
Hold the adjustment handle up and release it from the back with a pick tool. Remove the three T20 screws and lift the side trim panel away from the seat.
- Disconnect and remove the switch
Unplug the switch connector by releasing its lock. Carefully pry the switch from the side panel and inspect the retainer tabs before fitting the replacement.
- Install the new seat switch
Press the replacement switch into the panel until its clips engage, then reconnect the electrical plug. Position the panel on the seat and reinstall its three T20 screws.
- Refit handle and test seat
Slide the adjustment handle onto its shaft until fully seated. Operate the switch in each direction and confirm the seat moves correctly before completing the repair.
Check your vehicle’s repair manual for exact specifications and fit.