How to Replace Window Regulator 97-01 Toyota Camry

Difficulty: Intermediate · About 60 min · Toyota Camry

Replace the power window regulator on a 1997–01 Toyota Camry, protecting the door water barrier and supporting the glass throughout removal.

Steps

1. Remove the interior door trim

   Use a trim tool to release the door panel fasteners and disconnect the switch wiring as needed. Keep track of clips and avoid pulling against attached cables.

2. Expose and secure the window

   Remove the handle fastener and access plate, then carefully peel back the moisture barrier without tearing it. Reconnect the window switch temporarily, raise the glass, and tape it securely to the frame.

3. Remove the old regulator

   Disconnect the motor wiring and unbolt the glass from the regulator. Support the glass while removing the regulator and motor fasteners, then guide the assembly out through the door opening.

4. Install the replacement assembly

   Attach the motor if it is supplied separately, then feed the regulator into the door. Route the wiring correctly, align the tracks with their mounting points, and tighten the fasteners evenly.

5. Attach and test the glass

   Lower the supported glass onto the regulator and secure it. Reconnect the switch and operate the window through its travel, checking for smooth movement without binding or unusual noise.

6. Restore the moisture barrier and trim

   Unplug the switch and reinstall the water shield, sealing it back to the door. Reconnect the door controls and refit the trim panel, confirming all clips and handles are secure.

Check your vehicle’s repair manual for exact specifications and fit.