How to Replace Front Heater Blower Motor 09-15 Honda Pilot
Difficulty: Beginner · About 25 min · Honda Pilot
Replace the front HVAC blower motor on a 2009–2015 Honda Pilot by removing the lower glove box cover, disconnecting the motor, and testing its operation.
Tools you will need
- 8mm socket and ratchet
Parts and supplies
- Front blower motor
Steps
- Lower the glove box cover
Pull the cover beneath the glove box down and out of its retainers. Set it aside without pulling on attached wiring or damaging the panel clips.
- Remove the blower motor
Disconnect the motor's wiring connector and free its harness retainer. Remove the three 8mm mounting bolts, then lower the motor carefully from its housing.
- Install the replacement motor
Clip the harness retainer into position and raise the replacement blower into the housing. Align the mounting points, start the bolts by hand, tighten them to specification, and reconnect the electrical plug.
- Refit the cover and test
Press the lower glove box cover into its retainers. Run the blower through several speeds and confirm it operates without rubbing or excessive vibration.
Check your vehicle’s repair manual for exact specifications and fit.