How to Replace Serpentine Belt 96-98 Jeep Grand Cherokee
Difficulty: Beginner · About 30 min · Jeep Grand Cherokee
Replace the serpentine belt on a 1996-1998 Jeep Grand Cherokee.
Tools you will need
- 15mm wrench
- 15mm socket
- Ratchet
Parts and supplies
- Serpentine belt
Steps
- Remove the old belt
Note the routing diagram, loosen the tensioner pulley's 15mm bolt with a wrench, remove the second 15mm bolt on top of the tensioner with a socket and ratchet, then pull the belt off.
- Install the new belt
Route it around the pulleys per the diagram, use the 15mm wrench to relieve the tensioner and loop the belt over it, bolt the second 15mm bolt back in to restore tension, then finish tightening the tensioner pulley bolt until there's about a quarter inch of play, and start the engine to confirm it runs correctly.
Check your vehicle’s repair manual for exact specifications and fit.