How to Replace Rear Sway Bar Link 07-10 Hyundai Elantra

Difficulty: Intermediate · About 60 min · Hyundai Elantra

Replace a worn rear stabilizer link on a 2007–2010 Hyundai Elantra, keeping the suspension safely supported during removal.

Steps

1. Raise and support the rear

   Loosen the wheel nuts slightly while the car is on the ground, chock the front wheels, then raise and support the rear at approved points. Remove the wheel and inspect the opposite link and bushings for damage before proceeding.

2. Remove the worn stabilizer link

   Support the suspension so the link is not under heavy torsional load. Hold the stud with locking pliers where appropriate, remove the upper and lower nuts, and withdraw the link without damaging the stabilizer bar or mounting brackets.

3. Fit the replacement link

   Position the new link in the original orientation and start both nuts by hand. Hold the studs against rotation with the specified tool and tighten the nuts to the vehicle specification; ensure the boots are not twisted or pinched.

4. Reinstall the wheel and inspect

   Refit the wheel and hand-start its nuts, then lower the vehicle and tighten them in a star pattern to the vehicle specification. Check that the link clears nearby parts and listen for noise during a cautious road test.

Check your vehicle’s repair manual for exact specifications and fit.