How to Replace Front Sway Bar Links 03-11 Honda Element
Difficulty: Intermediate · About 40 min · Honda Element
Replace the front sway bar links on a Honda Element, counterholding each stud and tightening the new links evenly on both sides.
Tools you will need
- Floor Jack
- Jack Stands
- 15mm Socket
- 14mm Wrench
- 5mm Hex Wrench
- Torque Wrench
Parts and supplies
- Front sway bar links, pair
Steps
Lift and remove the wheel
Loosen the wheel fasteners on the ground, raise and support the vehicle, then remove the wheel to access the link.
Remove the old link
Hold the link stud with the appropriate hex tool while removing the upper and lower nuts. Withdraw the link and compare its orientation with the replacement.
Install the new link
Place the new link in the original orientation and start both nuts by hand. Counterhold each stud while tightening the fasteners to vehicle-specific specifications.
Refit the wheel and finish
Reinstall the wheel and tighten its lug nuts to specification in a crossing pattern. Lower the vehicle and check for unusual noises during a short, careful drive.
Check your vehicle’s repair manual for exact specifications and fit.