How to Remove Bumper Cover 11-17 Toyota Camry
Difficulty: Intermediate · About 75 min · Toyota Camry
Remove and reinstall the front bumper cover on a 2011–2017 Toyota Camry, protecting the grille and fog-light wiring and confirming all retainers and splash shields are secure.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Jack Stands
- 10mm Socket
- Ratchet
- Floor Jack
- Trim Tool Set
Parts and supplies
- Bumper-cover retainers
Steps
- Release the radiator and splash shields
Open the hood and remove the radiator-shield clips, lifting the shield out of the way. Raise and support the vehicle safely, remove the lower splash-shield bolts, and lower the shield enough to reach the bumper wiring.
- Disconnect wiring and release bumper fasteners
Unplug the fog-light harness if equipped. Turn and release the wheel-well lock pins, remove the wheel-well screws and grille clips, then release the bumper edges from their side retainers.
- Remove the bumper cover
With a helper supporting the cover, pull it forward evenly from both sides and lift it away from the vehicle. Store it on a padded surface so the painted finish and tabs are protected.
- Reinstall and align the bumper cover
Reconnect the fog-light harness, align the cover with the grille and fender guides, and press its sides into the retainers. Reinstall the wheel-well screws, lower bolts, grille clips, and radiator shield.
- Check the bumper fit and lighting
Confirm the panel gaps are even and each clip is fully seated. Recheck the splash shield is secured, then test fog lights and verify no wiring is trapped behind the bumper.
Check your vehicle’s repair manual for exact specifications and fit.