How to Replace Wiper Arms 00-07 Toyota Highlander

Difficulty: Beginner · About 20 min · Toyota Highlander

Replace the windshield wiper arms on a 2000–2007 Toyota Highlander while preserving the blade park position and avoiding contact with the glass.

Steps

1. Mark the wiper position

   Park the wipers and switch off the ignition. Use tape to mark each blade’s resting position on the windshield so the replacement arms can be aligned correctly.

2. Remove the old arm

   Lift the end cap and remove the retaining nut. Raise the arm and rock it gently at the pivot until it releases from the splines, supporting it to prevent it from striking the windshield.

3. Install the new arm

   Place the replacement arm on the pivot and align its blade with the tape mark. Start and tighten the retaining nut to the vehicle specification, then press the cap back into place.

4. Check the sweep

   Remove the tape and test the wipers with washer fluid on a wet windshield. Confirm the blades park correctly and clear the glass without hitting trim or each other.

Check your vehicle’s repair manual for exact specifications and fit.