How to Replace Power Window Motor 01-06 Hyundai Elantra
Difficulty: Beginner · About 30 min · Hyundai Elantra
Replace the power window motor on a 2001–2006 Hyundai Elantra by removing the door panel and water shield, transferring the motor, and testing window travel.
Tools you will need
- Razor Blade / Gasket Scraper
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Wrench
- 10mm Socket
- Ratchet
Parts and supplies
- Power window motor
Steps
Remove the door panel and water shield
Switch off the ignition. Pry off the fastener covers and remove the door-pull, handle, and panel screws. Release the panel clips and lift the panel away, unplug the window switch, then peel the water shield back carefully.
Disconnect and remove the window motor
Unplug the window motor harness and remove its three 10 mm retaining nuts. Carefully separate the motor from the regulator, keeping the regulator and glass supported so they do not shift unexpectedly.
Install the replacement motor
Align the replacement motor with the regulator gear and mounting studs, then press it fully into place. Reinstall and tighten the three nuts evenly and reconnect the electrical harness.
Reassemble and test the window
Reconnect the window switch temporarily and cycle the glass to confirm smooth movement. Switch the ignition off, restore the water shield, reconnect the switch harness, and reinstall the door panel, screws, clips, handle bezel, and trim covers.
Check your vehicle’s repair manual for exact specifications and fit.