How to Change Engine Oil 03-11 Honda Element
Difficulty: Beginner · About 60 min · Honda Element
Change engine oil and filter on a 2003–2011 Honda Element. Confirm oil grade and capacity for the installed engine, support the vehicle securely, and verify the level and leaks after startup.
Tools you will need
- Floor jack
- Jack stands
- Drain pan
- 17mm wrench
- Oil filter wrench
- Paper towels
Parts and supplies
- Engine oil
- Oil filter
Steps
Drain the used oil
Warm the engine briefly, switch it off, and raise the vehicle at approved points on jack stands. Position a drain pan, remove the plug, and allow the oil to drain fully.
Remove the old oil filter
Loosen the filter with a filter wrench and catch the remaining oil. Wipe the mounting surface clean and make sure the old gasket is not stuck to it.
Install the new filter
Lightly oil the new gasket and install the filter by hand following the filter maker's directions. Refit the drain plug and tighten it to vehicle specification.
Refill and check the engine
Lower the vehicle, add the specified oil amount through the filler, and secure the cap. Start briefly, check for leaks, wait a few minutes, then verify and adjust the dipstick level.
Check your vehicle’s repair manual for exact specifications and fit.