How to Replace Window Regulator 01-06 Dodge Stratus
Difficulty: Intermediate · About 4 min · Dodge Stratus
Replace the window regulator on a 2001–2006 Dodge Stratus by supporting the glass before separating it from the regulator and checking the window's travel before reassembly.
Tools you will need
- 10mm Socket
- Ratchet
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Putty Knife
Parts and supplies
- Window regulator, with motor if required
Steps
Remove the door trim
Pry off the pull and handle trim, remove the screws, and release the panel clips. Unplug the window switch and latch cables, lift the panel away, then carefully peel back the water shield.
Support and disconnect the glass
Loosen the glass-to-regulator fasteners and raise the window by hand. Secure it firmly to the door frame with suitable tape before removing any regulator hardware.
Remove the old regulator
Unplug the window motor and remove the rail and motor fasteners. Guide the regulator out through the access opening without scratching the glass or cutting the door wiring.
Install the new regulator
Feed the replacement into the door and hang it on its mounting point. Secure its rail and motor fasteners, reconnect the motor, then lower the glass onto the regulator and tighten its clamps.
Test the window and reassemble
Remove the tape while supporting the glass and cycle the window through its full travel. If it binds, correct the alignment before restoring the water shield, switches, latch cables, and door panel.
Check your vehicle’s repair manual for exact specifications and fit.