How to Replace Window Regulator 02-06 Honda CR-V
Difficulty: Intermediate · About 70 min · Honda Cr-v
Replace the front power window regulator on a 2002–2006 Honda CR-V by supporting the glass, exchanging the regulator, and reconnecting the door wiring before testing the window.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- 10mm Socket
- Ratchet
Parts and supplies
- Front power window regulator
Steps
Remove the door panel
Switch off the ignition. Release the door-panel clips and trim, remove the latch and door-pull screws, and unplug the switch panel. Disconnect the lock rod and hatch-release wiring, then lift the panel away and peel back the water shield carefully.
Support the glass and remove the regulator
Remove the two glass-to-regulator bolts and raise the glass fully by hand. Secure it with painter's tape across the top of the door frame. Unplug the window motor and remove the regulator fasteners, then guide the regulator out through the door opening.
Install the replacement regulator
Feed the new regulator into the door and align it with its mounting holes. Install and tighten its fasteners, reconnect the motor wiring, and confirm the regulator track is positioned to meet the supported glass.
Reconnect and test the window
Support the glass while removing the tape, then lower it onto the regulator clips and secure it with both bolts. Reconnect the switch temporarily and cycle the window to check smooth travel, then switch off the ignition and disconnect the switch again.
Reinstall the water shield and panel
Press the water shield back onto the door and route the harnesses through their openings. Reconnect the lock, hatch, and switch wiring, align the panel, and press its clips into place. Reinstall the screws and trim, then verify the window and locks.
Check your vehicle’s repair manual for exact specifications and fit.