How to Replace Wiper Transmission Linkage Bushings 97-01 Toyota Camry
Difficulty: Intermediate · About 60 min · Toyota Camry
Replace worn wiper-transmission linkage bushings on a 1997–2001 Toyota Camry, marking arm positions before disassembly and checking the park position after reassembly.
Tools you will need
- 1/2 Inch Drill Bit
- Socket Extensions
- Flat Blade Screwdriver
- Rubber Mallet
- 14mm Socket
- Drill
- Painter's Tape
- 10mm Socket
- Ratchet
- Needle nose pliers
- Marker / Writing Utensil
Parts and supplies
- Wiper linkage bushings
Steps
Mark and remove the wiper arms
Place tape at each blade's resting position on the windshield. Remove the arm nuts and work the arms free from their splined shafts.
Remove the cowl panel
Release the clips and separate the cowl panel from the weatherstrip on both sides. Lift the panels away carefully to avoid cracking their tabs.
Remove the wiper transmission
Unplug the motor lead and remove the transmission bolts. Lift the linkage assembly out of the cowl area and note the motor and arm alignment marks.
Separate the linkage arms
Mark the arms and motor positions before separating them. Pry each arm from its bushing carefully and keep the parts arranged in their original order.
Remove and install the bushings
Drill out the worn bushings without enlarging the linkage holes. Press the replacements squarely into the arms using a vise or suitable press until each seats fully.
Reassemble and test the linkage
Align the marks and press the arms into the new bushings. Reinstall the transmission, reconnect the motor, and cycle the wipers once to confirm proper park.
Reinstall the cowl and arms
Clip the cowl panels and weatherstrip back into place. Align each wiper arm to its tape mark, tighten the nuts to specification, and test all wiper speeds.
Check your vehicle’s repair manual for exact specifications and fit.