How To Install Timing Belt Cover 01-06 Hyundai Elantra
Difficulty: Advanced · About 120 min · Hyundai Elantra
Replace the timing-belt cover on a 2001–2006 Hyundai Elantra while supporting the engine before removing its mount. This procedure does not replace or retime the belt; keep debris out and use the correct mount and cover torque specifications.
Tools you will need
- Floor jack
- Jack stands
- Engine support bar
- 10mm socket
- 14mm socket
- 17mm socket
- Ratchet
- Torque wrench
Parts and supplies
- Timing-belt cover
Steps
Support the vehicle and engine
Raise and support the front of the car at approved points. Support the engine using the manufacturer's method before removing a mount; do not load a thin oil pan with a jack.
Move the engine mount and reservoir
Remove the upper mount fasteners only after the engine is securely supported. Move the power-steering reservoir and its bracket aside without disconnecting or stressing the hoses.
Remove the timing cover
Remove the side and front bracket fasteners, then remove the timing-cover bolts and lift the cover away. Keep dirt and loose hardware clear of the timing belt and pulleys.
Install the cover and mount
Seat the cover without pinching wiring or seals and start each fastener by hand. Tighten the cover and brackets to the correct service specifications, then reinstall the engine mount and reservoir bracket.
Remove support and inspect
Confirm the mount is fully seated and all fasteners are tightened to specification before gradually removing engine support. Check belt clearance and that the reservoir and hoses are secure.
Check your vehicle’s repair manual for exact specifications and fit.