How to Replace Windshield Wiper Motor & Linkage 04-10 Dodge Ram
Difficulty: Intermediate · About 60 min · Dodge Ram
Replace the windshield wiper motor and linkage on a 2004–2010 Dodge Ram by removing the cowl panels and transferring the rubber protector and washer hoses.
Tools you will need
- 10mm socket
- Ratchet
- T25 driver
- Wire cutters
- Trim tool
Parts and supplies
- Windshield wiper motor and linkage assembly
Steps
Remove the wiper arms
Raise each arm and release its retaining tab. Slide the arm off its splined pivot and keep both arms labeled for their original sides.
Remove the cowl covers
Remove the T25 fasteners and release the cowl clips. Lift away the deadening material and weatherstrip, disconnect the washer hoses from their retainers, and remove the cowl panels.
Remove the motor and linkage
Unplug the wiper motor connector and remove the three 10mm mounting bolts. Lift the motor and linkage assembly from the vehicle.
Install the replacement assembly
Transfer the rubber protector to the new assembly and position it on the vehicle. Reinstall the three mounting bolts and reconnect the motor plug.
Restore the cowl
Reinstall both cowl sections, secure their clips and T25 fasteners, and route the washer hoses through their retainers. Refit the weatherstrip and sound deadening.
Install and test the wiper arms
Press each arm onto its original splined pivot and secure its retaining tab. Test wiper operation and washer spray, confirming the arms park correctly.
Check your vehicle’s repair manual for exact specifications and fit.