How to Replace Ignition Coil 99-10 Honda Odyssey
Difficulty: Intermediate · About 25 min · Honda Odyssey
Replace an ignition coil on a 1999-2010 Honda Odyssey.
Tools you will need
- Socket extensions
- Flat blade screwdriver
- T40 bit
- 10mm socket
- Ratchet
Parts and supplies
- Ignition coil
Steps
- Remove the engine covers
Remove the upper cover's four 10mm bolts and lift it off, loosen the lower cover's two plastic clips with a flat blade screwdriver, then lift it off too.
- Remove the old ignition coil
Disconnect its wiring harness, remove its T40 Torx bolt, then pull the coil up and out.
- Install the new ignition coil
Push it into place, insert the T40 Torx bolt, connect the wiring harness, then repeat for the remaining coils.
- Reinstall the engine covers
Push the lower cover on and tighten its clips with a flat blade screwdriver, then push the upper cover on and insert its four 10mm bolts.
Check your vehicle’s repair manual for exact specifications and fit.