How to Replace Tie Rod 92-00 Honda Civic

Difficulty: Advanced · About 30 min · Honda Civic

Replace the tie rod, preserving the original toe setting, on a 1992-2000 Honda Civic.

Steps

1. Remove the wheel

   Loosen the lug nut covers, pry off the center cap, loosen the lug nuts with the car on the ground, raise and support it, then remove the lug nuts and wheel.

2. Remove the old tie rod

   Measure and record the distance from the boot to the outer tie rod, loosen the 19mm nut with a 19mm wrench, pull the cotter pin, remove the castle nut with a 17mm socket, strike the knuckle with a hammer, then twist the tie rod out.

3. Install the new tie rod

   Twist it on, push the outer end down into the knuckle, replace the castle nut, insert the cotter pin and bend its ends apart with pliers, measure again to confirm it matches the old distance (adjusting the joint with a 14mm wrench if needed), then tighten the 19mm nut.

4. Reattach the wheel

   Slide it into place, start the lug nuts by hand, lower the car, torque the lug nuts to about 100 ft-lb in a star pattern, then refit the center cap.

Check your vehicle’s repair manual for exact specifications and fit.