How to Change Oil and Filter 1.8T 04 Volkswagen Jetta and Golf
Difficulty: Beginner · About 60 min · Volkswagen Jetta
Change oil and filter on a 2004 Volkswagen Golf or Jetta with the 1.8T engine. Confirm oil grade and filter fitment, use jack stands, then inspect for leaks and verify the dipstick level.
Tools you will need
- Floor jack
- Jack stands
- Drain pan
- 8mm hex wrench
- T25 Torx driver
- Oil filter wrench
- Funnel
Parts and supplies
- Engine oil
- Oil filter
Steps
Raise the car and drain oil
Warm the engine briefly, switch it off, then lift the car at approved points and place it on stands. Position a pan, remove the hex drain plug, and allow the oil to empty.
Remove the splash shield
Remove the Torx fasteners holding the lower shield and set the panel aside. Keep its screws organized for reassembly.
Replace the filter
Loosen and remove the filter over the drain pan, then clean the mounting surface. Oil the new gasket and tighten the replacement by hand as directed.
Refit and refill
Install the drain plug with any required washer and tighten to vehicle specification. Refit the shield, lower the vehicle, and add the specified oil quantity.
Check the final level
Secure the filler cap and run the engine briefly. Inspect around the filter and drain plug for leaks, wait a few minutes, then verify and adjust the dipstick level.
Check your vehicle’s repair manual for exact specifications and fit.