How To Replace Power Window Motor 01-06 Dodge Stratus
Difficulty: Intermediate · About 90 min · Dodge Stratus
Replace the power window motor on a 2001–2006 Dodge Stratus, removing the door panel and glass track to transfer the motor and test the regulator before final reassembly.
Tools you will need
- Socket Extensions
- Flat Blade Screwdriver
- Phillips Head Screwdriver
- Putty Knife
- T30 Driver
- 10mm Socket
- Door Panel Removal Tool
- Ratchet
- Flashlight
- Needle nose pliers
Parts and supplies
- Power window motor
Steps
Remove the door panel
Pry off the pull and handle bezels, remove their screws and the lower panel screws, then release the panel and mirror trim. Disconnect the lock harness, latch rod, and switch wiring before lifting the panel away.
Remove the regulator and glass
Peel back the water shield without tearing it. Remove the regulator fasteners, release the glass from its track, raise the glass by hand, and unplug the motor before withdrawing the regulator.
Transfer the window motor
Remove the T25 screws holding the motor to the regulator. Align the replacement motor gears with the regulator drive, press the motor into position, and tighten its screws.
Reinstall the regulator
Reconnect the motor and switch, then guide the regulator into the door and start its fasteners by hand. Move the mechanism slightly with the switch to align it, seat the glass in its track, and secure the glass fasteners.
Reassemble and verify operation
Restore the water shield and reconnect the panel wiring and latch rod. Refit the door panel, locating tab, clips, screws, and trim, then test the regulator and window before driving.
Check your vehicle’s repair manual for exact specifications and fit.