How to Replace Driveshaft Center Bearing 05-10 Chrysler 300
Difficulty: Advanced · About 180 min · Chrysler 300
Replace the driveshaft center support bearing on a 2005–2010 Chrysler 300, marking the shaft sections before separation and keeping the exhaust supported during removal.
Tools you will need
- A Piece of Pipe (for leverage)
- Socket Extensions
- Torque Wrench
- Hammer
- Rust Penetrant
- Pry Bar
- Jack Stands
- Complete Metric Wrench Set
- T60 Torx Socket
- Bearing Puller
- Bearing Grease
- Bungee Cord
- Wire Ties
- Ratchet
- Floor Jack
- Swivel
- Assistant
- Marker / Writing Utensil
- Complete Metric Socket Set
Parts and supplies
- Driveshaft center support bearing
Steps
Lower the exhaust
Raise and support the vehicle, unplug the oxygen sensors, and remove the heat shield and exhaust fasteners. Have a helper support the exhaust as you release its hangers.
Mark and remove the driveshaft
Mark the shaft orientation at the transmission and differential flanges. Remove the flange fasteners, support the shaft, unbolt the center support, and lower the assembly carefully.
Separate the driveshaft sections
Mark the spline relationship before separating the two shaft sections. Remove the old center bearing with an appropriate puller, protecting the shaft yoke from damage.
Install the replacement bearing
Apply the specified grease to the bearing surface and slide the replacement onto the shaft with its bracket oriented correctly. Use a suitable sleeve to press it on evenly, then align the shaft marks.
Reinstall the driveshaft
Raise the shaft into place and align the flange marks. Start all bolts by hand, install the center support, and torque driveline fasteners to the vehicle's specification.
Restore exhaust and inspect
Reinstall the exhaust, heat shield, and oxygen-sensor connectors. Start the engine to check for exhaust leaks, then road-test gently for vibration or noise.
Check your vehicle’s repair manual for exact specifications and fit.