How to Replace Rear Wiper Arm 00-07 Toyota Highlander

Difficulty: Beginner · About 30 min · Toyota Highlander

Replace the rear wiper arm on a 2000–2007 Toyota Highlander, using a puller if corrosion has seized the arm to its spindle.

Steps

1. Remove the arm cover and nut

   Pry the trim cover from the wiper arm base and apply penetrant to the retaining nut if it is corroded. Remove the 10mm nut and try rocking the arm free from its spindle.

2. Free a seized arm

   If the arm remains stuck, thread the nut back on by hand to protect the spindle threads. Fit a wiper arm puller and turn its forcing screw until the arm releases, then remove the puller and nut.

3. Install the replacement arm

   Slide the replacement arm onto the spindle in its parked position. Start the retaining nut by hand, tighten it securely, and clip the trim cover back over the base.

4. Check the wiper sweep

   Run the rear wiper and confirm it moves across the glass and returns to its park position without contacting trim. Correct the arm position if necessary.

Check your vehicle’s repair manual for exact specifications and fit.