How to Replace Sway Bar Link 05-10 Pontiac G6
Difficulty: Beginner · About 50 min · Pontiac G6
Replace a front stabilizer link on a 2005–2010 Pontiac G6, counterholding both studs while fitting the new link and restoring the wheel and center cap.
Tools you will need
- A Piece of Pipe (for leverage)
- 18mm Wrench
- Jack Stands
- 18mm Socket
- 19mm Socket
- Ratchet
- Floor Jack
Parts and supplies
- Front stabilizer link
- Wheel lug nuts
Steps
Remove the wheel
Remove the center cap and loosen the lug nuts on the ground. Raise and support the vehicle securely, remove the wheel nuts, and take off the wheel.
Remove the worn link
Turn the wheel for access, hold the upper stud with an 18 mm wrench, and remove its nut. Counterhold the lower stud while removing its nut, then pull the link free.
Install the replacement link
Position the new link and start both nuts by hand. Hold each stud with the wrench as you tighten its nut, ensuring both ends seat correctly.
Reinstall the wheel and cap
Refit the wheel and snug its lug nuts in a crossing pattern. Lower the vehicle, torque the nuts to specification, and reinstall the center cap and lug cover.
Check your vehicle’s repair manual for exact specifications and fit.