How to Replace Rear Door Check Strap 01-06 Chrysler Sebring

Difficulty: Intermediate · About 45 min · Chrysler Sebring

Replace the rear door check strap on a 2001–2006 Chrysler Sebring to restore controlled door opening and stopping.

Steps

1. Remove the rear door panel

   Pry off the handle and pull trim, remove their screws and the lower panel screws, then release the panel clips with a trim tool. Lift the panel away, unplug the window switch, detach the latch cables, and peel back the water shield carefully.

2. Remove the worn check strap

   Pull back the rubber boot and remove the check strap fasteners at the door and body. Withdraw the old strap through the door opening while supporting the door and keeping the wiring clear.

3. Install the replacement strap

   Feed the new strap through the opening and orient it to match the original. Start the body and door fasteners by hand, tighten them to the vehicle specification, and reconnect the rubber boot.

4. Reassemble and check door travel

   Restore the water shield, reconnect latch cables and switch wiring, then hang the panel and press its clips home. Reinstall the screws and trim, and open and close the door to verify each detent holds and movement is smooth.

Check your vehicle’s repair manual for exact specifications and fit.