How to Replace Liftgate Handle 07-14 Honda Fit
Difficulty: Intermediate · About 3 min · Honda Fit
Replace the liftgate handle on a 2007–2014 Honda Fit, transferring the latch cable and trim while preserving the rear-wiper arm alignment and testing the latch afterward.
Tools you will need
- Pry Bar
- 8mm Socket
- 10mm Socket
- Ratchet
- Pocket Screwdriver
- Pick
Parts and supplies
- Compatible liftgate handle
Steps
Open a stuck liftgate if needed
Use the interior access cover to reach the latch release. Move the lock lever to the unlocked position, then operate the release lever to open the hatch.
Remove trim and release the handle
Mark the rear-wiper arm position before removing its cap and nut. Release the interior trim and exterior applique clips, then disconnect the latch cable and handle fasteners.
Install the new handle
Position the replacement handle and secure its nuts. Reconnect the latch cable, align the exterior trim, and press its clips into place before reinstalling the inner panel.
Restore the wiper and test
Align the wiper arm with the original mark and tighten its nut. Refit the cover, then test the handle, lock, rear wiper, and hatch closure.
Check your vehicle’s repair manual for exact specifications and fit.