How to Replace Rear Brake Caliper 07-11 Honda CR-V
Difficulty: Advanced · About 90 min · Honda Cr-v
Replace a rear brake caliper on a 2007–2011 Honda CR-V, install new sealing washers at the hose fitting, and bleed the system before returning the vehicle to service.
Tools you will need
- 12mm Socket
- Socket Extensions
- Flat Blade Screwdriver
- 17mm Wrench
- Pry Bar
- 17mm Socket
- 19mm Socket
- Bungee Cord
- 10mm Wrench
- Ratchet
- 1/2 Inch Breaker Bar
Parts and supplies
- Rear brake caliper
- New brake-hose sealing washers
- Specified brake fluid
Steps
Raise the vehicle and remove the wheel
Loosen the wheel nuts, raise and support the CR-V securely, and remove the wheel. Place a catch pan beneath the caliper before opening the hydraulic line.
Remove the old caliper
Remove the rotor retaining screw and caliper slide bolts, then support the caliper. Remove the bracket as needed and disconnect the brake hose while catching fluid.
Install the caliper and hose
Position the new caliper and attach the hose using new sealing washers on both sides of the fitting. Reinstall the bracket and pads, tightening fasteners to vehicle specifications.
Bleed the brake system
Fill the reservoir with the specified fluid and bleed the caliper using the vehicle's sequence until no air remains. Keep the reservoir from running low and secure the bleeder cap.
Reinstall the wheel and inspect
Refit the wheel and torque its nuts to specification. Pump the pedal until firm, check the hose and bleeder for leaks, and test braking carefully at low speed.
Check your vehicle’s repair manual for exact specifications and fit.