How to Replace Rear Power Window Regulator 05-10 Volkswagen Jetta
Difficulty: Advanced · About 75 min · Volkswagen Jetta
Replace the rear power window regulator on a 2005–10 Volkswagen Jetta, removing the exterior door skin for access and securing the glass to the new mechanism.
Tools you will need
- Flat blade screwdriver
- T20 driver
- T25 Torx driver
- T30 Torx bit
- Needle-nose pliers
Parts and supplies
- Rear window regulator assembly
Steps
Remove the interior door panel
Release the pull handle trim and remove its screws and the lower panel screw. Lift the panel away and disconnect the latch cables, lock wiring, window switch, speaker, and courtesy light.
Remove the exterior door skin
Release the lock bezel and exterior handle, then remove the perimeter fasteners. Pull the outer panel away carefully, keeping track of longer screws and their positions.
Support the glass and remove regulator
Release the glass from the regulator carrier and raise it by hand, supporting it securely. Unplug and remove the motor, release the regulator fasteners, and guide the assembly out.
Install the new regulator
Position the replacement regulator in the door and secure its fasteners. Reinstall the motor, reconnect its wiring, and confirm the mechanism moves before attaching the glass.
Attach and test the glass
Lower the glass carefully onto the regulator carrier until it locks into place. Operate the window through its travel and check that it remains aligned without binding.
Reinstall both door panels
Refit the exterior skin and handle, then reconnect the lock, speaker, light, window, and latch wiring. Align the interior trim panel, seat its clips, and reinstall its screws.
Check your vehicle’s repair manual for exact specifications and fit.