How to Replace AC Compressor Belt 98-04 Dodge Intrepid
Difficulty: Intermediate · About 55 min · Dodge Intrepid
Replace the A/C compressor belt on a Dodge Intrepid by recording both belt routes and controlling each tensioner as it is released.
Tools you will need
- 13mm Socket
- 15mm Wrench
- 1/2 Inch Ratchet
- 13mm Wrench
Parts and supplies
- A/C compressor belt
- Outer accessory belt, if worn
Steps
Record belt paths and remove the outer belt
With the engine cool and off, photograph the belt routing. Loosen the outer tensioner hardware, slip the belt from the pulleys, and release the tensioner slowly.
Remove the A/C belt
Remove the A/C tensioner fasteners as needed. Rotate the tensioner in the direction that relieves belt load, then slide the old A/C belt free.
Install the A/C belt
Route the replacement around the A/C and crank pulleys using the underhood diagram. Release the tensioner gradually and reinstall its retaining fasteners.
Reinstall and check the outer belt
Route the outer belt around the crank, alternator, idler, and power steering pulleys according to the diagram. Set tension to specification, tighten the hardware, and check alignment after startup.
Check your vehicle’s repair manual for exact specifications and fit.