How to Replace Front Wheel Bearings 2006 Chrysler 300
Difficulty: Advanced · About 105 min · Chrysler 300
Replace a front hub and bearing assembly on a 2006 Chrysler 300, then restore the brakes and torque the axle and wheel fasteners to vehicle specifications.
Tools you will need
- 35mm Socket
- Socket Extensions
- Torque Wrench
- Hammer
- Channel-Lock Pliers
- Jack Stands
- Brake Parts Cleaner
- Gloves
- Rubber Mallet
- Flat Blade Screwdriver
- Paper Towels
- Bungee Cord
- Anti-Seize Grease
- Chisel
- Ratchet
- Wire Brush
- Floor Jack
- 1/2 Inch Breaker Bar
- Complete Metric Socket Set
Parts and supplies
- Front hub and bearing assembly
- Brake pads or rotor, if needed
Steps
Raise the vehicle and remove the wheel
Loosen the wheel nuts on the ground, raise the front, and support the vehicle securely. Remove the wheel and loosen the axle nut while the hub is accessible.
Remove the caliper and rotor
Unbolt the caliper bracket and support the caliper so the hose is not stretched. Remove the pads and bracket, then free the rotor from the hub and clean the exposed mounting surface.
Remove the old hub
Remove the hub dust cover and axle nut. Separate the hub from the knuckle with controlled force, keeping the dust shield and ABS wiring protected, then withdraw the bearing assembly.
Install the replacement hub
Clean the knuckle bore and mating surfaces. Seat the new hub squarely, reinstall the axle nut and dust shield, and tighten the axle fastener to the vehicle's specification.
Reassemble the brake components
Clean and inspect the brake hardware, lubricating only the designated slide and pad contact points. Reinstall the rotor, bracket, pads, and caliper, tightening fasteners to specification.
Install the wheel and inspect
Refit the wheel and torque its lug nuts to specification. Pump the brake pedal until firm, verify the ABS lead is secure, and check for abnormal play or noise before driving.
Check your vehicle’s repair manual for exact specifications and fit.