How To Change Engine Oil and Filter 00-07 Ford Taurus 3.0L V6

Difficulty: Beginner · About 45 min · Ford Taurus

Change the engine oil and filter on a 2000–2007 Ford Taurus 3.0L V6, using the oil grade and fill quantity specified for the vehicle and checking carefully for leaks after startup.

Steps

1. Position a drain pan and drain the oil

   Park on level ground, let hot components cool enough to handle, and place a drain pan beneath the oil pan. Remove the filler cap, loosen the drain plug, and let the oil drain completely before fitting a new washer and reinstalling the plug to specification.

2. Remove the old oil filter

   Move the drain pan under the filter and loosen it with a filter wrench. Keep it upright as you lower it, then wipe the filter mounting surface clean and verify the old gasket came off with the filter.

3. Install the replacement filter

   Apply a thin film of fresh oil to the new filter gasket and thread the filter on squarely by hand. Tighten it according to the filter instructions; avoid cross-threading or overtightening the housing.

4. Refill and check for leaks

   Add the specified oil through a funnel, starting below the full capacity. Start the engine briefly, inspect the drain plug and filter for leaks, shut it off, wait for oil to settle, and use the dipstick to bring the level into range.

Check your vehicle’s repair manual for exact specifications and fit.