How To Change Transmission Fluid 02-07 Jeep Liberty
Difficulty: Advanced · About 120 min · Jeep Liberty
Replace the automatic-transmission filter and fluid on a 2002–2007 Jeep Liberty by lowering the pan. Use the exact transmission fluid and pan-sealing method for the installed unit, keep debris out, and verify level using its specified procedure.
Tools you will need
- Floor jack
- Jack stands
- Drain pan
- 10mm socket
- T25 Torx driver
- Gasket scraper
- Funnel
Parts and supplies
- Transmission filter
- Transmission pan gasket
- Automatic transmission fluid
Steps
Raise the vehicle and drain the pan
Check the service information and fluid level procedure first. Raise the vehicle on approved points and support it level on stands, place a wide pan underneath, and loosen pan bolts gradually so fluid drains in a controlled way.
Remove the filter and clean the pan
After draining, remove the remaining pan fasteners and lower the pan carefully. Remove the filter, clean the pan and magnet, and scrape old gasket material without gouging sealing surfaces.
Install the filter and reseal the pan
Fit the correct replacement filter and seal. Install the specified gasket or sealant following its cure instructions, position the pan, and tighten bolts evenly to transmission-maker specification.
Refill and check transmission level
Add the specified fluid through the fill point, start the engine, and cycle the selector as directed. Check the level using the exact temperature and engine-running procedure for this transmission; correct leaks before driving.
Check your vehicle’s repair manual for exact specifications and fit.